Linksys PAP2
The Linksys Phone Adapter enables use of our high-quality
feature-rich telephone service through your cable or DSL Internet
connection. Just plug it into your home Router or Gateway
and use the two standard telephone jacks to connect your existing
phones. Each phone jack operates independently, with separate
phone service and phone numbers -- like having two phone lines.
With IP Net, you'll get clear telephone reception, even
while using the Internet at the same time for normal data
operations.
STEP 1
You must first determine what IP address it received. To
do this, you need to pick up the phone attached to the Line
1 jack and dial:
**** (four asterisks)
then dial:
110 #
and you will be told the IP address of your device (e.g.
192.168.0.100)
STEP 2
Go to any browser equipped computer on your network and enter
the address: http://<IP ADDRESS>/
(where <IP ADDRESS> is replaced by the address that
was given to you in STEP 1.
STEP 3
Click on the "Admin Login" button near the top
right side of the screen (please contact Rubicon Tech Support at support@rubiconnetworks.com for username and password), then click on the "Line 1"
tab.
STEP 4
You need to modify only a few parameters from the factory
default. They are listed here:
| Proxy : |
sip.myvoipaccount.net |
| Display Name : |
Enter your Full name, this will show
up as part of your callerid. |
| User ID : |
Enter the phone number you chose when
you signed up for IP Net service. |
| Password : |
Enter the password that you chose
when you signed up for IP Net service. |
STEP 5
To save bandwidth, you can change Line 1 "Preferred
Codec" to G729a. Also change the "Use Pref Codec
Only" to Yes. You can only do this for one line. So,
if Line 1 is on G.729a, Line 2 has to be some other codecs.
We do not support G.723.
STEP 6
Click on the "Save Settings " button at the bottom
of the form.
STEP 7
Make calls!
|
